Gel for volumetric designs 3D Jelly Gel №3

3D Jelly Gel is a decorative gel without a sticky layer for creating relief elements and 3D designs on nails. The tube format makes it easy to dose and apply the material directly to the nail.

Features:

• It does not have a sticky layer.
• Suitable for linear, dot and relief designs;
• Suitable for forming designs using molds.
• Allows you to create a variety of three-dimensional elements.
• Conveniently controlled directly from the tube.
• The wavelength for polymerization is 365–405 nm.
• UV/LED lamp power is 36–48 W.

Recommendations for work:

For uniform polymerization, we recommend forming elements up to 2 mm thick. To create a larger volume, we recommend layering the material, polymerizing each layer separately.

When working with molds, the element can be polymerized directly on the nail: fill the mold with material, attach it to the nail, and dry in a lamp.

For the most accurate result, we recommend forming and curing the element separately, without removing it from the mold. After polymerization, remove the finished element, fix it on the nail with Rubber Base and additionally secure with a top coat.

Application method

1. Perform standard nail preparation and apply the necessary coating depending on the design technique: base, gel, gel polish or top.
2. Carefully squeeze the desired amount of 3D Jelly Gel directly from the tube onto the nail. Using a liner or other tool, form a linear, dot or volumetric element up to 2 mm thick.
3. Cure in a UV/LED lamp for 120 seconds. After polymerization, be sure to let the material cool.
4. If necessary, cover the design with a top coat, especially if a rub, color or other decorative elements were applied to the gel surface. Cure the top coat for 120 seconds.

Working with Moldas
Method 1
1. Fill the mold with material.
2. Apply the mold to the nail and cure in a UV/LED lamp for 120 seconds. Let the material cool, then carefully remove the mold.
3. Be sure to cover the design with a top coat for more reliable fixation and better wear resistance. Cure for 120 seconds.

Method 2
1. Fill the mold with material and polymerize the element without removing it from the mold for 120 seconds.
2. Let the material cool, remove the finished element and fix it on the nail using Rubber Base. Cure for 120 seconds.
3. Be sure to cover the design with a top coat for more reliable fixation and better wear resistance. Cure for 120 seconds.

Composition: Acrylates Copolymer, Isobornyl Acrylate, Isobornyl Methacrylate, Silica, CI 77491, CI 77492, CI 77891, CI 77007, CI 77266, Ethyl Trimethylbenzoyl Phenylphosphinate.

TPO FREE
(Product photos on the website may differ from the actual product)